Just Resin RiverPour 2:1

How to use this product data

EpoxyCalc currently catalogs this system for river table, deep pour, mold casting. The stored general maximum layer is 50 mm (2.0 in). The listed mix ratio is 2:1 by weight. Always measure using the method stated by the manufacturer because weight and volume ratios are not automatically interchangeable.

This page is a planning reference, not a substitute for the current technical data sheet. Re-check the manufacturer guidance before a large pour, especially when temperature, total mass or project geometry is near a published limit. Product availability and prices can also change after the verification date shown above.

Need the exact resin and hardener amounts for this product's published ratio? Use the resin and hardener ratio calculator and keep the manufacturer's weight / volume basis unchanged.

Verified notes

• For general river-table planning EpoxyCalc uses a conservative 50 mm maximum layer.
• The manufacturer also publishes deeper-pour examples for much smaller total masses, so pour depth is not treated as independent of batch/project mass.
• Kit volumes are approximate and derived from the manufacturer's own published standard-price-per-litre comparisons, not from a generic epoxy density.
• The industrial 600 kg option is excluded from consumer kit optimization; pricing is therefore marked partial.

Kit and price snapshots

Some merchant links may be affiliate links. EpoxyCalc may earn a commission at no extra cost to you. Affiliate disclosure

Manufacturer sources