GlassCast 50 PLUS Super Deep Cast

Project-specific pour limits

Temperature-dependent pour limits

These are manufacturer-published project limits stored by EpoxyCalc. The calculator uses a conservative published temperature point rather than interpolating a more permissive value.

How to use this product data

EpoxyCalc currently catalogs this system for river table, deep pour, mold casting. The stored general maximum layer is 50 mm (2.0 in). The listed mix ratio is 2:1 by volume. Always measure using the method stated by the manufacturer because weight and volume ratios are not automatically interchangeable.

This page is a planning reference, not a substitute for the current technical data sheet. Re-check the manufacturer guidance before a large pour, especially when temperature, total mass or project geometry is near a published limit. Product availability and prices can also change after the verification date shown above.

Need the exact resin and hardener amounts for this product's published ratio? Use the resin and hardener ratio calculator and keep the manufacturer's weight / volume basis unchanged.

Verified notes

• TDS publishes temperature-dependent maximum pour depths; EpoxyCalc uses the conservative published table rather than a single static limit.
• At 20°C the published maximum is 50 mm into wood and 80 mm into a thin-walled mould.
• The manufacturer explicitly states that litres can be approximated as kilograms for quantity planning; kg-to-L values below are therefore marked approximate.
• Only the 5 kg and 15 kg public prices have been independently verified so far; the 30 kg option is excluded from value ranking.

Kit and price snapshots

Some merchant links may be affiliate links. EpoxyCalc may earn a commission at no extra cost to you. Affiliate disclosure

Manufacturer sources