EPODEX ECO+ / PRO+ Casting System

How to use this product data

EpoxyCalc currently catalogs this system for river table, deep pour, mold casting. The stored general maximum layer is 50 mm (2.0 in). The listed mix ratio is 2:1 by volume. Always measure using the method stated by the manufacturer because weight and volume ratios are not automatically interchangeable.

This page is a planning reference, not a substitute for the current technical data sheet. Re-check the manufacturer guidance before a large pour, especially when temperature, total mass or project geometry is near a published limit. Product availability and prices can also change after the verification date shown above.

Need to convert this product between litres / gallons and kilograms / pounds? Use the epoxy resin density & weight calculator with the verified density above.

Need the exact resin and hardener amounts for this product's published ratio? Use the resin and hardener ratio calculator and keep the manufacturer's weight / volume basis unchanged.

Verified notes

• Official EPODEX guidance states a maximum 5 cm layer for river tables and larger castings; much deeper pours are only described for small castings.
• Mix ratio is 2:1 and the published processing time is approximately 6 hours, with 48–72 hours before the next casting / handling stage.
• Minimum processing temperature is 15°C and the manufacturer lists 20°C as the recommended processing temperature.
• The public product page currently presents starting prices and selectable variants; EpoxyCalc does not infer a purchasable kit combination from the starting-price display.

Kit and price snapshots

Some merchant links may be affiliate links. EpoxyCalc may earn a commission at no extra cost to you. Affiliate disclosure

Manufacturer sources