Craft Resin Deep Pour Epoxy
Technical data used by EpoxyCalc to decide whether this product fits a project. Values are sourced from the manufacturer and show the last verification date below.
How to use this product data
EpoxyCalc currently catalogs this system for river table, deep pour, mold casting. The stored general maximum layer is 50.8 mm (2.0 in). The listed mix ratio is 2:1 by volume. Always measure using the method stated by the manufacturer because weight and volume ratios are not automatically interchangeable.
This page is a planning reference, not a substitute for the current technical data sheet. Re-check the manufacturer guidance before a large pour, especially when temperature, total mass or project geometry is near a published limit. Product availability and prices can also change after the verification date shown above.
Need the exact resin and hardener amounts for this product's published ratio? Use the resin and hardener ratio calculator and keep the manufacturer's weight / volume basis unchanged.
Verified notes
- Manufacturer states a maximum 2 in / 5 cm per layer for large open molds.
- Recent manufacturer guidance gives a 2:1 mix ratio by volume and 100:45 by weight.
- Recommended working temperature is approximately 21–27°C (70–80°F).
- Full cure is stated as roughly 72–96 hours under recommended conditions.
Kit and price snapshots
Some merchant links may be affiliate links. EpoxyCalc may earn a commission at no extra cost to you. Affiliate disclosure
Manufacturer sources
Calculate your actual project first.
Quantity, project type, pour depth and temperature determine whether a product is a useful match.